Hp Hitachi Dynamic Link Manager Software Manual do Utilizador descarregar pdf (Página 236)

100

101

4. HDLM Operation

214

Check the NPIV Option line.

3. Place in Offline (C) status the path that goes through the Fibre Channel switch to

be replaced.

Depending on the NPIV option setting for the

dlmodmset utility checked in step

2, execute one of the following commands:

• If the NPIV option is set to

off:

Specify the HBA adapter number and bus number, and then execute the

command shown below. The following example shows how to place the path

in Offline (C) status when the path goes through an HBA whose HBA

adapter number is

08 and whose bus number is 11:

# /usr/DynamicLinkManager/bin/dlnkmgr offline -hba 08.11

• If the NPIV option is set to

on:

Use the

fscsi number found in step 1 to execute the command below. The

following example shows how to place the path in Offline (C) status when

the path goes through

fscsi number 1 (fscsi1):

# /usr/DynamicLinkManager/bin/dlnkmgr offline -hba 00.01

4. Execute the following command to delete the path that goes through the Fibre

Channel switch to be replaced:

Specify the device name (

fscsi device) of the HBA connected to the Fibre

Channel switch that is to be replaced to delete the path (where n is the instance

number of the

fscsi device).

# rmpath -p fscsi

n -d

Because the fscsi number found in step 1 is 1 (fscsi1), the result is as follows:

# rmpath -p fscsi1 -d

5. Execute the following command to get the name of the parent device:

# lsdev -C -l fscsin -F parent

1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 509 510

Comentários a estes Manuais

Sem comentários

Hp Hitachi Dynamic Link Manager Software Manual do Utilizador Página 236

Comentários a estes Manuais

Manuais e produtos relacionados com Armazenamento Hp Hitachi Dynamic Link Manager Software