Hp RDX Removable Disk Backup System Manual do Utilizador descarregar pdf (Página 29)

Power LED

Table 3 Power LED

LED Status Mea ning

Action require

OFF

No power

Check the power cable connection and replace the cable

if necessary. You can use the power cable from your

monitor or another device to check that the connection is

working.

If the power supply is present and the LED remains off,

power cycle or reset the drive. If it still fails, call for

service.

Steady GREEN

The drive is ready

for operation

None. This is normal.

Blinking GR

EEN

Ejecting

None. The un

it is ejecting the cartridge.

Steady AMBER Fault

The unit has detected a fault condition. This may be

because:

• the u nit cannot eject the c artridge due to an

obstruction

• the internal electronics are damaged or

malfunctioning

Use a straightened paper clip in the Emergency Eject

Hole to remove a stuck ca rtridge, as described in

“Emergency eject” on page 30. If this does not resolve

the problem, run the RDX diagnostic application.

Blinking AMBER

Prevent

None. The host server is accessing the media and the

user has pressed th e eject button. The unit will blink

amber for a few seconds then return to steady green.

Wait for host access to complete, after which the unit

will eject the cartridge. If it does not, you may not be

running the correct RDX utilit y, see “RDX Removable Disk

utility” on page 12. Install the RDX utility and try again.

If necessary, use Windows Explorer to eject the cartridge

(right-click on the drive letter for the RDX Removable D isk

Backup System and select Eject).

RDX Removable Disk Backup System

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 37 38

Comentários a estes Manuais

Sem comentários

Hp RDX Removable Disk Backup System Manual do Utilizador Página 29

Comentários a estes Manuais

Manuais e produtos relacionados com Armazenamento Hp RDX Removable Disk Backup System