Hp StorageWorks 1000 Modular Smart Array Manual do Utilizador descarregar pdf (Página 40)

40 Using the CLI

Host connection commands

Each time the MSA is powered on, all active HBA connections to the MSA are automatically detected and

identified by their WWPN.

Before a host accesses the storage of the MSA, you must identify the operating system (host mode) of each

connection. HP also recommends assigning a user-defined name to each connection, to make the

identification and setup of each connection easier.

After connections are established, be sure to restrict access to the LUNs to specific hosts. The CLI uses an

Access Control List (ACL) to enter the list of LUNs a host can access. See ”Access Control List commands”

on page 43 for more information about SSP and ACLs.

Each of the following commands is used to enter and manage the connections:

• Adding a connection

• Changing the profile of a connection

• Changing the user-defined name of a connection

• Deleting the user-defined name of a connection

• Creating a new profile

• Moving to a different profile

• Changing the profile mode

NOTE: Use the show connections command to display information about each HBA connected to the

MSA, including connection name, WWPN, and profile. See ”Show commands” on page 19 for an

example display.

Adding a connection

If the host is not yet connected to the MSA, but WWPN of the HBA is known, you can use this command to

manually add, name, and identify the connection.

Basic command

add connection <ConnectionName> <wwpn=xxxxxxxx-xxxxxxxx> [profile=profile_name]

[offset=offset_value]

Command options

ConnectionName—the user-defined name to give the connection, up to 16 alphanumeric characters.

wwpn=xxxxxxxx-xxxxxxxx—the WWPN of the active HBA inside the host attached to the MSA.

The show connections command can be used to obtain the WWPN.

profile=profile_name—the platform of the host. Options include:

Default—is not operating-system specific and should not be used; use a valid pre-defined name.

Windows

OpenVMS

Tru64

Linux

Solaris

Netware

offset=offset_value—(default: 0) the unit offset for assigning logical volumes.

Example command and response

CLI> add connection MSA-1 wwpn=12345678-12345678 profile=windows

Connection MSA-1 has been added successfully.

Profile Windows is set for the new connection.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

Comentários a estes Manuais

Sem comentários

Hp StorageWorks 1000 Modular Smart Array Manual do Utilizador Página 40

Comentários a estes Manuais

Manuais e produtos relacionados com Armazenamento Hp StorageWorks 1000 Modular Smart Array