Hp StorageWorks 2.32 Edge Switch Manual do Utilizador descarregar pdf (Página 165)

Edge Switch Element Manager user guide 165

To add a new preferred path:

TIP: You may need to configure preferred paths on multiple switches or directors to optimize load

balancing for an entire path between devices.

1. Select Configure > Preferred Path.

The Configure Preferred Paths dialog box is displayed as shown in Figure 66.

Figure 75 Configure Preferred Paths dialog box

The Configure Preferred Paths dialog box provides the configuration for a single switch’s

preferred path.

NOTE: Some columns are displayed only when the FICON Management Style feature has

been installed.

2. Take the appropriate action:

• If a warning message is displayed notifying you that the switch or director has not been

configured for insistent domain ID:

• Close the dialog box and select Configure > Operating Parameters > Switch Parameters.

• Select the Insistent check box in the Configure Switch Parameters dialog box.

• Return to the Configure Preferred Paths dialog box and continue to step 3.

• If there is no warning message, continue with step 3.

3. Click Add to configure a new preferred path.

The Add Preferred Path dialog box is displayed as shown in Figure 67.

Figure 67 Add Preferred Path dialog box

4. Click the lists for the Source Port, Exit Port, and Destination Domain ID to make your selections.

See ”Exporting the Configuration Report” on page 132 for more information.

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 227 228

Sem comentários

Hp StorageWorks 2.32 Edge Switch Manual do Utilizador Página 165