Hp StorageWorks All-in-One SB600c Storage Blade Manual do Utilizador descarregar pdf (Página 24)

CAUTION:

To prevent possible server malfunction and damage to the equipment, multiprocessor conﬁgurations must

contain processors with the same part number.

CAUTION:

To prevent possible server blade overheating, always populate processor socket 2 with a processor and a

heatsink or a processor cover and a heatsink blank.

CAUTION:

The heatsink thermal interface media is not reusable and must be replaced if the heatsink is removed

from the proces

sor after it has been installed.

IMPORTANT:

When installing the heatsink, align the guide pins on the processor retenti on bracket with the alignment

holes in the heatsink.

IMPORTANT:

Processor socket 1 must always be populated. If processor socket 1 is empty, the server blade does not

power up.

NOTE:

Do not discard the processor protective cover. Alway s install the pr ocessor protective cover if the

processor is removed from the socket.

To install the component:

1. Power down the server blade.

See Powering d

own the HP All-in-One SB600c Storage Blade Solution on page 19 for more

information.

2. Remove the server blade.

See Removing the HP AiO SB600c Server Blade on page 20 for more information.

3. Remove the ac

cess panel.

See Remov ing the access panel on page 21 for more information.

4. Remove all hard drives.

5. Remove the ha

rd drive backplane.

Hardware O ptions i nstallation and cabling

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 59 60

Sem comentários

Hp StorageWorks All-in-One SB600c Storage Blade Manual do Utilizador Página 24