Hp StorageWorks DAT 72x10 Tape Autoloader Manual do Utilizador descarregar pdf (Página 22)

NOTE:

If the robotics have failed, it may not be possible to return the unit to the home position and you will be

unable to ﬁtthe shipping lock.

Fitting the autoloader cover (optional)

WARNING!

The HP StorageWorks DAT 72x10 Tape Autoloader weighs 10.45 kg (23.4 lb.) without media, and

12 kg (26.46 lb.) when both magazines are full (10 cartridges). To reduce the risk of personal injury or

damage to the autoloader, 1) observe local health and safety requirements and guidelines for manual

material handing, 2) obtain adequate assistance to lift and stabilize the autoloader during installation or

removal, 3 ) always remove all tapes to reduce the overall weight of the autoloader.

1. If the autoloader has plastic feet, they must be removed so the autoloader can ﬁtinsidethe tabletop

conversion cover. With assistance, gently turn the autoloader over and set it on its b ack, as shown

below. Peel off the plastic feet. Turn the autoloader right side up.

Figure 5 Removing the plastic feet

2. Slide the autoloader into the autoloader cover until the front panel of the autoloader is aligned

with the cover.

3. Tighten

the

two captive screws on the autoloader front panel until the cover is secure.

Figure 6 Installin g t he autoloader cover

4. You are

now ready to connect the SCSI cable and power cord.

Installing the autoloader

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 61 62

Sem comentários

Hp StorageWorks DAT 72x10 Tape Autoloader Manual do Utilizador Página 22