HP 220mx Manual do Utilizador descarregar pdf (Página 29)

Chapter 1 1-17

Setting Up the Jukebox

Connecting Power

Chapter 1: Setting

up the Disk Drive

Setting Up the

Jukebox

Connecting Power

1. Ensure that the power switch on the jukebox is OFF (“5” on Figure 1-1)

NOTE Use the power cord shipped with the jukebox.

2. Route the power cord through the strain relief clip (“4” on Figure 1-1) and close

the clip snugly around the cord.

3. Plug the socket end of the power cord into the power port on bottom of the

power distribution assembly ( “9” on Figure 1-1).

4. Continue to route the power cable down, through the long cable slot at the

bottom of the jukebox right side panel, and out through the cable access hole at

the lower left rear of the jukebox (“7” on Figure 1-1).

5. Plug the other end of the power cord into a three-hole grounded outlet.

6. Press the power switch ON (“8” on Figure 1-1)

When power is applied, TESTING and NOT READY alternately display. Once

the poweron test completes (approximately 1.5 minutes), READY displays.

NOTE If DEVICE FAILED displays. See “Troubleshooting” in Chapter 3 for

troubleshooting procedures.

7. Refer to Chapter 3, “Operating the Jukebox” for instructions on setting the SCSI

addresses, loading optical disks into the jukebox, setting a password, etc.

NOTE Continue on to “Configuring Write Verify” on the next page.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 119 120

Sem comentários

HP 220mx Manual do Utilizador Página 29