HP 220mx Manual do Utilizador descarregar pdf (Página 76)

3-36 Chapter 3

Operating the Jukebox

Troubleshooting

Table 3-4 Troubleshooting

Problem What to do

Jukebox won’t power on. • Ensure that power cord connections are tight.

• Ensure that the power switch is ON (located on

the lower right side of the jukebox rear panel).

• Ensure that the power outlet is operating.

• Replace the power cord with a known good one.

• If steps above are unsuccessful, call your service

representative.

Poweron selftest failed

and DEVICE FAILED

displays

• Power cycle the jukebox.*

• If the poweron test continues to fail, press

ENTER, write down the displayed error code, and

call your service representative.

DEVICE FAILED

displays.

Hardware Error #61

(External SCSI cables) is

reported.

• Ensure that only one SCSI device type

(single-ended OR differential) exists on the SCSI

bus.

• Verify that the SCSI interface selection switch is

set correctly (either single-ended or differential).

• Verify that the terminator is the correct type

(single-ended or differential).

• If steps above are unsuccessful, call your service

representative.

Power to the jukebox

failed while a disk was in

the drive and the display

did not return to READY

after the power came back

on.

• Power cycle the jukebox.*

• If READY does not display (poweron test is

unsuccessful), switch off the power. Do not move

the unit! Moving the unit risks damaging the

optical drive. Call your service representative.

Ensure that the SCSI bus is inactive before removing power to the jukebox.

Removing power to a device on an active SCSI bus can cause data loss and/or

problems with the SCSI interface.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 119 120

Comentários a estes Manuais

Sem comentários

HP 220mx Manual do Utilizador Página 76

Comentários a estes Manuais

Manuais e produtos relacionados com não HP 220mx