Hp HSG Array Controller Manual do Utilizador descarregar pdf (Página 25)

2-6 StorageWorks Fibre Channel Storage Switch User's Guide

Compaq Confidential – Need to Know Required

Writer: Bill Reitz Project: StorageWorks Fibre Channel Storage Switch User's Guide Comments: V1.6 OEM Source

Part Number: AA-RHBYA-TE 135267-001 File Name: c-ch2 Installing the Switch Last Saved On: 4/7/99 1:45 PM

2. Pencil–mark the mounting bracket holes on each side of the rack with an

3. Slide a clip nut over the marked hole on each rear rail (Figure 2–3).

4. Attach a mounting bracket to the rails on each side of the rack and

secure each bracket with three 10–32x5/8 SEMS screws; tighten the

screws at the front before you tighten the one at the rear.

5. Go to the section entitled Attaching the Slide Brackets to the Switch.

SHR-1380

Mounting bracket; Clip nut

Figure 2-3. Installing the Mounting Brackets in a RETMA 41U Rack

Attaching Mounting Brackets in a RETMA 42U or

Compaq Rack

You can mount the Switch in this rack from either the front or the rear of the

rack. Perform the following steps:

1. Position the mounting template against the front and rear vertical rails

(Figure 2–2), first on one side of the cabinet and then on the other side;

make sure the template is parallel from front–to–rear.

IMPORTANT:

In a rack–front installation the template front should be positioned against

the front rail; in a rack–rear installation the template front should be positioned against

the rear rail.

2. Pencil–mark the mounting bracket holes on each side of the rack with

an M.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 247 248

Sem comentários

Hp HSG Array Controller Manual do Utilizador Página 25