Hp Netserver E Server series Manual do Utilizador descarregar pdf (Página 33)

4 Installing Additional Memory

Introduction

The HP NetServer’s main memory is implemented using four memory slots on the

system board and it supports up to 2 GB (512 MB x 4) of memory. The NetServer

uses only 3.3V, 168-pin, 133 MHz, buffered, SDRAM DIMMs and ships with at

least one 128 MB DIMM. The embedded video controller is provided with 4 MB

standard video memory and cannot be upgraded.

NOTE Use only PC 133 (133 MHz) SDRAM DIMMs acquired from

Hewlett-Packard. The EDO DIMMs and PC 100 SDRAM

DIMMs from earlier HP NetServer models will fit into the

DIMM slots in the HP NetServer E 800, but the EDO DIMMs

and PC 100 SDRAM will not function properly.

To ensure you have the correct DIMMs before installation, refer to one of the

following for a list of qualified DIMMs:

• HP Order Assistant on the HP web site at:

http://www.hp.com/go/netserver

• HP Customer Service

Tools Required

Use an anti-static service kit (3M 8501/8502/8503 or equivalent). This kit includes

a static-dissipating work surface, a chassis clip lead, and a wrist strap.

Memory Installation Guidelines

• The HP NetServer E 800 only uses 133 MHz (PC133) buffered SDRAM

DIMMs, which are electrically different from the EDO and PC100

SDRAM memory modules used in previous HP NetServer models.

• DIMMs sizes supported are 128 MB, 256 MB, or 512 MB in any

combination.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 105 106

Sem comentários

Hp Netserver E Server series Manual do Utilizador Página 33