Hp Server tc3100 series Manual do Utilizador descarregar pdf (Página 23)

Chapter 3 Hardware Installation and Configuration

Server is powered down. Serious injury may result if this

warning is not observed.

2. You must plug the Remote Management Card into slot 6.

Connecting the 50-pin Ribbon Cable to the Server

After you have physically installed the HP Server Remote Management Card into

slot 6 of your server, you must cable the card to the server's system board. One

end of the supplied ribbon cable should already be connected to the Remote

Control Card (see previous section). Connect the other end to the system board’s

50-pin connector that is immediately adjacent to the inserted card.

NOTE The ribbon cable is keyed to prevent incorrect cable

connection.

Figure 3-2: Installing the Remote Management Card

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 120 121

Sem comentários

Hp Server tc3100 series Manual do Utilizador Página 23