Hp DM4 Manual do Utilizador descarregar pdf (Página 72)

Reverse this procedure to install the USB board.

NOTE: When reinstalling note that the screw goes into the upper hole.

Power connector cable

Description Spare part number

Power connector cable (includes cable and connector) 608273-001

Before removing the power connector cable, follow these steps:

1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn

the computer on, and then shut it down through the operating system.

2. Disconnect all external devices connected to the computer.

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet

and then unplugging the AC adapter from the computer.

4. Remove the battery (see

Battery on page 36).

5. Remove the following components:

a. Hard drive (see

Hard drive on page 43)

b. Optical drive (select models only) (see

Optical drive on page 45)

c. Keyboard (see

Keyboard on page 47)

d. Top cover (see

Top cover on page 49)

e. USB board (see

USB board on page 63)

Remove the power connector cable:

1. Turn the computer upright with the right side toward you.

2. Disconnect the power connector cable (1) from the system board.

3. Remove the two Phillips M2.5×5.0 screws (2) that secure the power connector cable to the base

enclosure.

4. Lift the bracket from the connector (3).

64 Chapter 4 Removal and replacement procedures

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 112 113

Sem comentários

Hp DM4 Manual do Utilizador Página 72