HP Elite 8300 Series Small Form Factor Especificações descarregar pdf (Página 152)

100

101

Removing a Hard Drive from a Drive Bay

NOTE: Before you remove the old hard drive, be sure to back up the data from the old hard drive so

that you can transfer the data to the new hard drive.

1. Prepare the computer for disassembly (Preparation for Disassembly on page 119)

2. Remove the access panel (

Computer Access Panel on page 120)

3. Disconnect the power cable and data cable from the back of the hard drive.

4. Release the drive by pulling the release tab away from the drive (1) and sliding the drive out of

the bay (2).

Figure 7-21 Removing a Hard Drive

5. Remove the four guide screws (two on each side) from the old drive. You will need these screws

to install a new drive.

Installing a Hard Drive into an Internal Drive Bay

NOTE: The system does not support Parallel ATA (PATA) hard drives.

1. Prepare the computer for disassembly (Preparation for Disassembly on page 119)

2. Remove the access panel (

Computer Access Panel on page 120)

Drives 141

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 348 349

Comentários a estes Manuais

Sem comentários

HP Elite 8300 Series Small Form Factor Especificações Página 152

Comentários a estes Manuais

Manuais e produtos relacionados com Mini-PCs HP Elite 8300 Series Small Form Factor