HP J5730 Manual do Utilizador descarregar pdf (Página 170)

4. Insert the stack of paper into the input tray with the short edge forward and the

print side down. Slide the stack of paper forward until it stops.

CAUTION: Make sure that the HP All-in-One is idle and silent when you load

paper into the input tray. If the HP All-in-One is servicing the print cartridges

or otherwise engaged in a task, the paper stop inside the device might not be

in place. You could push the paper too far forward, causing the HP All-in-One

to eject blank pages.

TIP: If you are using letterhead, insert the top of the page first with the print

side down. For more help on loading full-size paper and letterhead, refer to

the diagram engraved in the base of the input tray.

5. Slide the paper-width guide inward until it stops at the edge of the paper.

Do not overload the input tray; make sure the stack of paper fits within the input

tray and is no higher than the top of the paper-width guide.

6. Replace the output tray.

Chapter 12

168 Troubleshooting

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 285 286

Sem comentários

HP J5730 Manual do Utilizador Página 170