HP 100VG Guia do Utilizador descarregar pdf (Página 38)

After you have connected the hardware together, you need to set up

HP Stack Manager. The basic steps to connect the hub to HP Stack Manager

with a modem link are:

1. Connect the “remote” modem that will be used on the hub to your PC’s

serial port.

2. Configure the “remote” modem by using the Remote Modem

initialization screen from the Settings menu in HP Stack Manager. This

configures the remote modem for correct operation with HP Stack

Manager.

3. Connect the “remote” modem to the RS-232 port on the back of the hub

using a standard “straight-through” modem cable. (For pinouts and

recommended cables, see appendix A, “Cables and Connectors”.) The

cable included with the hub will not work for connecting a modem

to the hub.

4. Connect the “local” modem to the serial port on your PC or install it in

the PC if it is an internal modem.

5. Configure the “local” modem by using the “Local Modem” initialization

screen in HP Stack Manager.

6. From the Communications screen under the Settings menu, click on

the Modem button.

7. Set the Baud Rate and enter the phone number of the remote modem.

8. From the main screen click on the [Connect] button to establish the

communication connection between the two modems. Once the

connection is established, the hub or stack of hubs will be displayed on

the HP Stack Manager’s main screen.

See the HP Stack Manager online help for more specific instructions.

Installing the

HP AdvanceStack Hub

Installing the HP AdvanceStack Hub

1-24

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 115 116

Sem comentários

HP 100VG Guia do Utilizador Página 38