HP 24S Guia do Utilizador descarregar pdf (Página 29)

Using a right-angle 50-pin connector:

1. Loosen the Velcro strap to make

room for the 50-pin connector.

2. Slip the connector inside the strap

and plug it into the twisted-pair port.

3. Pull down on the Velcro strap end

to tighten it, then pull up and secure

the end to the strap.

Note: If you are using a mixture of modular adapters and right-angle 50-pin connectors on

a Hub Plus/48, position the modular adapters on ports to the left of the 50-pin connectors.

For information on twisted-pair cabling schemes using the 50-pin connector, see the

HP EtherTwist Technical Reference Guide (part number 5091-3237E).

Using a straight-out 50-pin connector:

1. Remove the Velcro strap holder by unscrewing and removing the two screws that

hold it to the back of the hub.

2. Attach standoffs (p/n 1252-3056). You can use the standoffs from an unused

console port or form the back of the modular adapter that came with your hub (HP

28684B or 28688B only). Be careful not to over tighten the stand-offs. Damage to

the hub’s case could result.

3. Plug in the connector and secure it to the standoffs.

Twisted-pair port

Velcro strap

50-pin

connector

to cross-connect

block

Installation 2-11

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 101 102

Sem comentários

HP 24S Guia do Utilizador Página 29