
Reactivating the Primary Link
When the primary link is repaired, you can use any of the following methods to reenable
the primary port:
From the hub’s console, use the Port command, PO n ON where n is the
primary port’s ID.
Cycle power on the hub. This is useful if you do not have access to the hub’s
console interface (for example, because the hub is in a wiring closet and a console
is not connected).
From an HP network management station, reenable the port or reset the hub.
See the network management product documentation for details on how to enable
a port or reset the hub.
When the primary port is reenabled, the backup port is automatically disabled and
returned to backup mode.
Backup Links E-5
Comentários a estes Manuais