HP 8800 Router Series Manual de Instalação descarregar pdf (Página 12)

NOTE:

The appearance and installation methods of slide rails depend on the slide rail types.

Installing cage nuts to the rack

Before mounting the chassis to the rack, install cage nuts to the front square-holed brackets of the rack,

as shown in Figure 3.

When preparing for installation, make sure the total height of the routers to be installed does not

exceed the height of the rack, and reserve enough clearance for cable routing.

1. Align the mounting bracket with the left rack post, making sure the bottom edge and the slide

rail are level.

2. Mark the positions of the cage nuts on the rack post according to the installation holes on the

mounting bracket.

3. Install the cage nuts to the right positions. (Each installation hole on the mounting bracket

corresponds to one cage nut.)

4. Repeat steps 1 through 3 to install cage nuts to the correct rack post.

Figure 3 Installing the cage nuts

Installing the cable management brackets

This section includes separate steps for installing the cable management brackets on the A8808 and

A8805/A8812.

Installing the cable management brackets on the A8808

The A8808 has two cable management brackets and are installed using the same procedure. The

signal cable management brackets are installed at the upper part of the router, and the power cable

management brackets are installed at the lower part of the router.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 120 121

Sem comentários

HP 8800 Router Series Manual de Instalação Página 12