HP X09 Manual descarregar pdf (Página 20)

XStream‐PKG‐E™EthernetRFModem–ProductManualv5.x00[2006.02.24]

4. RFModemConfiguration

4.1. Hands-On Programming Examples

For more information about entering Command Mode, sending

commands and exiting Command Mode, refer to the Command Mode

section [p

18].

4.1.1. Configuration Setup Options

After installing the X-CTU and Com Port Redirector Software [refer to

8] to a PC, use one of the connection options below to send

commands to the XStream-PKG-E Ethernet RF Modem.

Option #1 – Local Network Connection

Connect a PC and the Ethernet RF Modem to active Ethernet connections of the same local

network [as shown in the figure below].

Figure4‐01. LocalNetworkConnection

©2006MaxStream,Inc.ConfidentialandProprietary 20

Option #2 – Direct PC Connection

Connect the Ethernet RF Modem directly to the PC through the PC’s Ethernet port [as shown in

the figure below].

Figure4‐02. DirectPCConnection

Configuration Setup:

1. Install both the X-CTU Software and the Ethernet Com Port Redirector [Refer to the ‘Install

Software’ [p8] section for more information].

2. Connect the Ethernet RF Modem to a PC using either a Local Network [p20] or a Direct PC

[20] connection.

3. Follow the steps outlined in the ‘Ethernet RF Modem Discovery’ section [p9] to identify the

com port that will be used to configure the RF modem.

4. Launch the X-CTU Software on the PC and select the PC Settings tab.

5. Make sure values shown in the fields of the ‘Com Port Setup’ section match those of the

Ethernet RF Modem.

[This example is continued on the following page]

Examplesinthissection

citetheuseofMaxStream’s

X‐CTUSoftwarefor

programmingtheRF

modem.Otherprograms

suchasTelnetSoftware

canalsobeusedto

ramthemodem.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 55 56

Sem comentários

HP X09 Manual Página 20