HP AlphaStation DS20 Guia de Instalação descarregar pdf (Página 24)

Linux Installation and Configuration Guide for AlphaServer 24

ECG513/0100

1. Type: swriteboot –f1 /dev/sdZ /boot/bootlx (where Z is the letter of the

drive you are booting; ex: dka0=sda, dka100=sdb). ). For example: swriteboot –f1

/dev/sda /boot/bootlx

2. Type: cd /boot

3. Type: mount /dev/scd0 /cdrom

4. Type: cp /cdrom/etc/vm_full.gz .

5. Type: umount /dev/scd0

6. During installation the YAST utility doesn't recognize the swap partition as defined and

therefore no swap partition is found in the /etc/fstab file. You will need to edit the /etc/fstab

file to add the swap partition entry manually, as follows:

/dev/sda3 swap swap defaults 0 0

7. After you have completed modifying the /etc/fstab file, you will need to be initialize it with

the command mkswap /dev/sda3. The changes will take effect after the system is rebooted.

8. To configure the X window System type: sax

Follow the prompts and answer the questions appropriately for your system. Once this process is

completed, you should be able to run the command "startx" to make use of the graphical

interface.

9. Type: shutdown –h now

Post-Installation

System Resource Manager Configuration

Now will make the final configuration changes to be able to boot directly from the disk, instead

of the floppy or CD-ROM. You should now be at the SRM prompt, ">>>". Enter the following

commands to finalize the configuration.

You need to enter these commands, such that the drive reference on the second line needs to refer

to the drive which you installed to:

>>>set boot_file 2/boot/vm_full.gz

>>>set bootdef_dev dka0

>>>set boot_osflags "root=/dev/sda2"

At the SRM prompt, you can now boot directly from the hard drive:

>>>boot

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 55 56

Sem comentários

HP AlphaStation DS20 Guia de Instalação Página 24