HP AlphaStation DS20 Guia de Instalação descarregar pdf (Página 31)

Linux Installation and Configuration Guide for AlphaServer 31

ECG513/0100

18. First cylinder: Type “3”.

19. Last cylinder: Type “28”.

20. Type “n” to add a new BSD partition – the swap partition in this case.

21. Type “c” for partition c.

22. First cylinder: Type “29”.

23. Last cylinder: Type “550”.

24. Type “n” to add a new BSD partition – the /usr partition in this case.

25. Type “d” for partition d.

26. First cylinder: Type “551”.

27. Last cylinder: Type “1023” ; last cylinder - one. Do NOT accept the program

generated default of "1024" here, because of possible disk corruption.

28. Type “p” to print the partition table. You should notice that the fstype is set to unused for

each of the partitions. This will have to be changed via “toggle” – see next step.

29. Type “t” to change the partitions filesystem id.

30. Type “a” for partition a – boot partitions use a “boot” code.

31. Type “L” to list the codes you can use.

32. Enter “d” for boot type.

33. Type “t” to change the partitions filesystem id.

34. Type “b” for partition b – / (root) partitions use a “ext2” code.

35. Enter “8” for ext2 type.

36. Type “t” to change the partitions filesystem id.

37. Type “c” for partition c – swap partitions use a “swap” code.

38. Enter “1” for swap type.

39. Type “t” to change the partitions filesystem id.

40. Type “d” for partition d – /usr partitions use a “ext2” code.

41. Enter “8” for ext2 type.

42. Type “p” to print the partition table – Please verify all your settings.

43. Type “w” to write the disklabel to the disk.

44. Type “q” to quit.

For further information on creating partitions please refer to the Installation Guide provided by

the software distribution vendor.

At this point, the partitions have been created, and the system must be rebooted. You can reboot

by either pressing the RESET or POWER buttons on the front of the AlphaServer system. Once

the system returns to the SRM prompt, follow the preceeding instructions to return to the

"Partition Hard Drives" window. Select the "Do Not Partition" option at this screen.

You will now be presented a window that allows you to select and format the disk for the

software to be installed, entitled "Creating Filesystems". Use the F5 =Expert menu key to change

the Inodes density on the following mount point only “/” or sda2 to a density of 1024. You

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 55 56

Sem comentários

HP AlphaStation DS20 Guia de Instalação Página 31