HP C4140 Manual do Utilizador descarregar pdf (Página 21)

To uninstall from a Mac and then reinstall

1. Disconnect the HP All-in-One from your Mac.

2. Open the Applications:Hewlett-Packard folder.

3. Double-click HP Uninstaller.

Follow the onscreen instructions.

4. After the software is uninstalled, restart your computer.

5. To reinstall the software, insert the HP All-in-One CD-ROM into your computer’s CD-ROM

drive.

6. On the desktop, open the CD-ROM and then double-click HP All-in-One Installer.

7. Follow the onscreen instructions and the instructions provided in the Setup Guide that came

with the HP All-in-One.

Hardware setup troubleshooting

Use this section to solve any problems you might encounter while setting up the HP All-in-One

hardware.

I connected the USB cable, but I am having problems using the HP All-in-One with my

computer

Cause The USB cable was connected before the software was installed. Connecting the

USB cable before prompted can cause errors.

Solution You must first install the software that came with the HP All-in-One before

connecting the USB cable. During installation, do not plug in the USB cable until prompted

by the onscreen instructions.

Once you have installed the software, connecting your computer to the HP All-in-One with a

USB cable is straightforward. Simply plug one end of the USB cable into the back of your

computer and the other into the back of the HP All-in-One. You can connect to any USB

port on the back of your computer.

For more information on installing the software and connecting the USB cable, see the

Setup Guide that came with the HP All-in-One.

The HP All-in-One will not turn on

Cause The HP All-in-One is not properly connected to a power supply.

Chapter 2

HP Photosmart C4100 All-in-One series

Troubleshooting and support

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 33 34

Sem comentários

HP C4140 Manual do Utilizador Página 21