HP DL280 Guia do Utilizador descarregar pdf (Página 41)

System BIOS configuration 41

hardware failures are accurately isolated during POST. The number of tests displayed depends on the

configuration of the server.

During POST you can:

• Press ESC to skip the HP logo and go to POST boot progress display system summary screen.

• Press F10 to access the Setup Utility.

• Press F12 to request a network boot (PXE).

• Press F1 to continue POST after POST errors are detected.

POST error indicators

When POST detects a system failure it displays a POST error message.

Recoverable POST errors

When a non-fatal error occurs during POST, the screen will display an error message with the format

“xxx-Error Identifier String” where “xxx” is a unique number code that matches ODM system specific

error documentation and may be a hexadecimal or decimal value.

All Error messages describe the problems as shown below:

Table 23

POST Error Messages

Error code Description

10 Floppy Controller Failure

00B CMOS Memory Size Wrong

00C RAM R/W test failed

003 CMOS Battery Low

005

CMOS Checksum Bad

040 Refresh timer test failed

041 Display memory test failed

048 Password check failed

120 $A0CCMOS Cleared by Jumper. Restore the Jumper and Continue…

122 $A0CPassword Cleared By Jumper. Restore the Jumper and Continue…

150

Processor failed BIST

160 Processor missing microcode:

192 L3 cache size mismatch

193

CPUID, Processor stepping are different

194 CPUID, Processor family are different

195 Front side bus mismatch. System halted.

196 CPUID, Processor Model are different

197 Processor speeds mismatched

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 49 50

Sem comentários

HP DL280 Guia do Utilizador Página 41