HP 10TB Guia do Utilizador descarregar pdf (Página 122)

Replacing the enclosure rails

1. Align the replacement rail, and then attach it by sliding the rail toward the front of the enclosure

(Figure 115 (page 122)).

Figure 115 Installing the enclosure rails

2. Align the replacement drive drawer rail with the three enclosure rails and then push the drive

drawer partially back into the system enclosure so that approximately two inches of the drawer

is still out of the enclosure (Figure 116 (page 122)).

CAUTION: Do not push the drive drawer completely into the enclosure. You must first connect

the power coil assembly to prevent damaging the power coil assembly.

Figure 116 Partially installing the drive drawer

3. Pull the cable slightly out of the coil power plug and connect it to the midplane board

(Figure 117 (page 123)).

122 Removing and replacing hardware components

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 180 181

Sem comentários

HP 10TB Guia do Utilizador Página 122