HP 10TB Guia do Utilizador descarregar pdf (Página 76)

the HP 10 GB Ethernet I/O module with a 1 GB module, follow the instructions in “Removing and

replacing the HP Ethernet I/O module” (page 94). If you need to shut down a server blade or the

storage system to replace a component, follow the instructions in “Powering the system off and

on” (page 76).

Powering the system off and on

Follow these steps to shut down a single server blade or to perform a system shutdown:

1. From the Windows desktop, shut down the server blades as follows:

a. While you are connected to blade 2, shut down blade 2 by clicking Start and then

selecting Settings→Power→Shut down.

b. Start and then selecting Settings→Power→Shut down.

NOTE: Let the Windows shutdown run to completion, which will power the blade off.

2. Power off any disks in disk enclosures by pressing and holding down the power button located

on the back of each disk enclosure.

3. Power off the storage system enclosure by pressing and holding down the power button located

on the back of the enclosure.

4. Disconnect the power cables (optional).

5. To power on the server blades and system, reconnect the power cables and power on the

components in the following order:

• System enclosure

• Server blades, if necessary (typically they start up when the enclosure is powered on)

76 Upgrading the storage system

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 180 181

Sem comentários

HP 10TB Guia do Utilizador Página 76