HP 10TB Guia do Utilizador descarregar pdf (Página 161)

SET IPCONFIG

Syntax

SET IPCONFIG { DHCP | STATIC | LOCAL }

Description

Configures EM addressing mode to be DHCP, static, or link local. The setting takes effect

immediately. If mode chosen is static, other parameters are required (see below).

Restrictions

None

SET IPCONFIG STATIC

Syntax

SET IPCONFIG STATIC <ip address> <netmask> [<gateway>]

Description

Configures the IP settings for the EM to static mode. In selecting this mode, the IP address and

netmask are be set to <ip address> and <netmask>, respectively. These settings take effect

immediately. The gateway address will be cleared if it is omitted. Note that you can also set the

gateway address using the SET EM GATEWAY command.

Restrictions

None

SHOW NETWORK

Syntax

SHOW NETWORK

Description

Displays the network settings of the Enclosure Manager.

Restrictions

None

SHOW EBIPA

Syntax

SHOW EBIPA

Description

Displays EBIPA configuration information.

Restrictions

EM EBIPA control only functions for the two iLO processors in the server blades.

Server management

Use the commands in this section to perform server management operations.

Server management 161

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 180 181

Sem comentários

HP 10TB Guia do Utilizador Página 161