HP P6350 Manual do Utilizador descarregar pdf (Página 115)

Presenting EVA storage for Linux

To set up LUNs using HP P6000 Command View:

1. Set up LUNs using HP P6000 Command View. For procedure steps, see Step 2.

2. Set up the iSCSI drive on the iSCSI Initiator:

a. Restart the iSCSI services:

/etc/rc.d/initd/iscsi restart

b. Verify that the iSCSI LUNs are presented to the operating system by entering the following

command:

fdisk -l

Setting up the iSCSI Initiator for VMware

The software iSCSI Initiator is built into the ESX server VMkernel and uses standard 10 GigE/GigE

NICs to connect to the iSCSI or iSCSI/FCoE modules.

To set up software-based iSCSI storage connectivity:

1. Install the appropriate license from VMware to enable the iSCSI software driver using the

VMware instructions.

2. Configure the VMKernel TCP/IP networking stack for iSCSI support. Configure the VMkernel

service console with dedicated virtual switch using a dedicated NIC for iSCSI data traffic.

Follow the instructions from VMware. Figure 54 (page 115) shows an example of a

configuration.

Figure 54 Configuration tab

3. Open a firewall port by enabling the iSCSI software client service:

a. Using the VMware VI client, select the server.

b. Click the Configuration tab, and then click Security Profile.

c. Click the Properties link.

The Firewall Properties dialog box is displayed (see Figure 55 (page 116)).

Set up the iSCSI Initiator 115

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 315 316

Sem comentários

HP P6350 Manual do Utilizador Página 115