HP NAS 8000 Clustered Solution Manual do Utilizador descarregar pdf (Página 215)

Command View SDM Limitations 213

Command View SDM

Limitations

The Command View Storage Device Manager (SDM) software is integrated

with the Command View NAS web interface and resides on the NAS server. It

manages the storage on any of the attached arrays. You can access the

Command View SDM from the Storage, Status, and Support tabs. The

Command View SDM lets you:

■

Edit or manage advanced storage features on the array

■

Monitor the status of the arrays

■

Download new firmware

You should only access the HP Command View SDM web interface when it is

called up by the Command View NAS interface. Features available in this

software can damage or delete data from your arrays. Always pay attention

to warnings that are displayed by the software.

Command View SDM is launched by the Command View NAS interface for

the following reasons:

■

Status (Failed State) — If there is failure in the storage array hardware,

the Command View NAS interface will not provide any details. Command

View SDM provides details about where within the array the fault has

occurred. This access is for information only.

■

Diagnostics (Support Tasks) — Diagnostic tools in Command View SDM

are available to assist with isolating problems. To perform diagnostics on

the storage array, the Command View NAS interface will start the

Command View SDM interface with the “diagnostic” tab selected. This

task should only be performed by an HP service representative.

■

Firmware Upgrade (Support Tasks) — The Command View SDM

interface “download” tab is accessed to upgrade storage array firmware.

This task should only be performed by an HP service representative.

■

Initial System Configuration — During initial system configuration, the

storage array settings should be verified using the Virtual Front Panel

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 239 240

Sem comentários

HP NAS 8000 Clustered Solution Manual do Utilizador Página 215