HP NAS 8000 Clustered Solution Manual do Utilizador descarregar pdf (Página 220)

218 Command View SDM Limitations

Configuration

(cont.)

Rebuild Priority This is set to Low. If a rebuild is required,

you may wish to alter this setting to allow

the rebuild to proceed more quickly. This

may result in a degradation of user

performance.

Type Do not changes this setting. Rebuilds are

set to automatically occur when required.

Start/Stop Disabled unless Manual Rebuild is

selected.

Diagnostics Array Shutdown This “turns off” I/O do the array but does

not power it down. Doing so without

stopping I/O at the NAS server (e.g.

turning off all shares/mounts) will cause

clients to have I/O failures. Be sure you

understand the affects of this operation

before using it. The NAS 8000 operating

system will automatically start this feature

when it boots.

Full Reset This feature should not be required in

normal operation. Resetting the array can

take several minutes. During this time, I/O

requests from the NAS server may time

out.

Partial Reset This feature should not be required in

normal operation. This takes less time than

a full reset; however, I/O requests from

the NAS server may still time out.

Restart The inverse of the “Shutdown” operation.

It turns back on I/O to the device.

Disk Include This feature is enabled in the Command

View NAS web interface.

Table 1 Command View SDM Limitations

Tab Page Feature Limitations

1 2 ... 215 216 217 218 219 220 221 222 223 224 225 ... 239 240

Sem comentários

HP NAS 8000 Clustered Solution Manual do Utilizador Página 220