HP PROCURVE 2520 Manual do Utilizador descarregar pdf (Página 288)

100

101

Port Trunking

Trunk Group Operation Using the “Trunk” Option

Dynamic/Static LACP Interoperation: A port configured for dynamic

LACP can properly interoperate with a port configured for static (TrkX) LACP,

but any ports configured as standby LACP links will be ignored.

Trunk Group Operation Using the

“Trunk” Option

This method creates a trunk group that operates independently of specific

trunking protocols and does not use a protocol exchange with the device on

the other end of the trunk. With this choice, the switch simply uses the SA/DA

method of distributing outbound traffic across the trunked ports without

regard for how that traffic is handled by the device at the other end of the

trunked links. Similarly, the switch handles incoming traffic from the trunked

links as if it were from a trunked source.

When a trunk group is configured with the trunk option, the switch automati-

cally sets the trunk to a priority of “4” for spanning-tree operation (even if

spanning-tree is currently disabled. This appears in the running-config file as

spanning-tree Trkn priority 4. Executing write memory after config-

uring the trunk places the same entry in the startup-config file.

Use the Trunk option to establish a trunk group between a switch covered in

thisguide and another device, where the other device’s trunking operation fails

to operate properly with LACP trunking configured on the switches.

12-26

1 2 ... 283 284 285 286 287 288 289 290 291 292 293 ... 543 544

Comentários a estes Manuais

Sem comentários

HP PROCURVE 2520 Manual do Utilizador Página 288

Comentários a estes Manuais

Manuais e produtos relacionados com Software HP PROCURVE 2520