HP PROCURVE 2520 Manual do Utilizador descarregar pdf (Página 404)

100

101

File Transfers

Copying Diagnostic Data to a Remote Host, PC or UNIX Workstation

Syntax: copy crash-data [<slot-id> | master] tftp <ip-address> <filename>

copy crash-data [<slot-id>| mm] xmodem

where: slot-id = a - h, and retrieves the crash log or crash data from

the processor on the module in the specified slot.

mm Retrieves crash log or crash data from the switch’s

chassis processor. When “mm” is specified, crash

files from both management modules are copied.

These commands copy the crash data content to a remote host

or to a serially connected PC or UNIX workstation. You can

copy individual slot information or the management module

(mm) switch information. If you do not specify either, the

command defaults to the mm data.

For example, to copy the switch’s crash data to a file in a PC:

At this point, press

[Enter] and start the

Xmodem command

sequence in your

terminal emulator.

Figure A-13.Example of Copying Switch Crash Data Content to a PC

Copying Crash Log Data Content to a Destination Device

Syntax: copy crash-log tftp <ip-address>

copy crash-log xmodem

These commands copy the Crash Log content to a remote host

or to a serially connected PC or UNIX workstation.

A-30

1 2 ... 399 400 401 402 403 404 405 406 407 408 409 ... 543 544

Comentários a estes Manuais

Sem comentários

HP PROCURVE 2520 Manual do Utilizador Página 404

Comentários a estes Manuais

Manuais e produtos relacionados com Software HP PROCURVE 2520