HP Q.11. (2510-24) Manual do Utilizador descarregar pdf (Página 181)

7-19

Configuring Secure Socket Layer (SSL)

General Operating Rules and Notes

Using the CLI interface to enable SSL

To enable SSL on the switch

1. Generate a Host certificate if you have not already done so. (Refer to “2.

Generate the Switch’s Server Host Certificate” on page 7-8.)

2. Execute the web-management ssl command.

To disable SSL on the switch, do either of the following:

■ Execute no web-management ssl.

■ Zeroize the switch’s host certificate or certificate key. (page 7-9).

Using the Web Browser Interface to Enable SSL

To enable SSL on the switch

i. Proceed to the Security tab then the SSL button

ii. Select SSL Enable to on and enter the TCP port you desire to

connect on.

iii. Click on the

[Apply Changes] button to enable SSL on the port.

To disable SSL on the switch, do either of the following:

i. Proceed to the Security tab then the SSL button

ii. Select SSL Enable to off .

iii. Click on the

[Apply Changes] button to enable SSL on the port.

Syntax: [no] web-management ssl

Enables or disables SSL on the switch.

[port < 1-65535 | default:443 >]

The TCP port number for SSL connections (default:

443). Important: See “Note on Port Number” on page

7-20.

show config

Shows status of the SSL server. When enabled, web-

management ssl appears in the config list.

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 293 294

Sem comentários

HP Q.11. (2510-24) Manual do Utilizador Página 181