HP Q.11. (2510-24) Manual do Utilizador descarregar pdf (Página 268)

9-26

Configuring and Monitoring Port Security

Operating Notes for Port Security

the alert flag status for the port referenced in the dropped entry. This means

that, even if an entry is forced off of the Intrusion Log, no new intrusions can

be logged on the port referenced in that entry until you reset the alert flags.

LACP Not Available on Ports Configured for Port Security. To main-

tain security, LACP is not allowed on ports configured for port security. If you

configure port security on a port on which LACP (active or passive) is

configured, the switch removes the LACP configuration, displays a notice that

LACP is disabled on the port(s), and enables port security on that port. For

example:

ProCurve(config)# port-security e a17 learn-mode static

address-limit 2

LACP has been disabled on secured port(s).

ProCurve(config)#

The switch will not allow you to configure LACP on a port on which port

security is enabled. For example:

ProCurve(config)# int e a17 lacp passive

Error configuring port A17: LACP and port security cannot

be run together.

ProCurve(config)#

To restore LACP to the port, you must remove port security and re-enable

LACP active or passive.

1 2 ... 263 264 265 266 267 268 269 270 271 272 273 ... 293 294

Sem comentários

HP Q.11. (2510-24) Manual do Utilizador Página 268