HP Q.11. (2510-24) Manual do Utilizador descarregar pdf (Página 201)

8-17

Configuring Port-Based and Client-Based Access Control (802.1X)

Configuring Switch Ports as 802.1X Authenticators

Configuring Switch Ports as 802.1X

Authenticators

1. Enable 802.1X Authentication on Selected Ports

This task configures the individual ports you want to operate as 802.1X

authenticators for point-to-point links to 802.1X-aware clients or switches,

and consists of two steps:

A. Enable the selected ports as authenticators.

B. Specify either client-based or port-based 802.1X authentication.

(Actual 802.1X operation does not commence until you perform step 5 on page

8-15 to activate 802.1X authentication on the switch.)

Note When you enable 802.1X authentication on a port, the switch automatically

disables LACP on that port. However, if the port is already operating in an

LACP trunk, you must remove the port from the trunk before you can config-

ure it for 802.1X authentication.

802.1X Authentication Commands Page

[no] aaa port-access authenticator < [ethernet] < port-list >8-17

server-timeout | logoff-period | max-requests | reauth-period |

auth-vid | unauth-vid | initialize | reauthenticate | clear-statistics]

8-18

aaa authentication port-access 8-23

< local | eap-radius | chap-radius >

[no] aaa port-access authenticator active 8-17

[no] port-security [ethernet] < port-list > learn-mode port-access 8-40

802.1X Open VLAN Mode Commands 8-26

802.1X Supplicant Commands 8-42

802.1X-Related Show Commands 8-47

RADIUS server configuration 8-24

1 2 ... 196 197 198 199 200 201 202 203 204 205 206 ... 293 294

Sem comentários

HP Q.11. (2510-24) Manual do Utilizador Página 201