HP R4.2 Manual do Utilizador descarregar pdf (Página 422)

100

101

A Summary of Commands attach

UCS 1000 R4.2 Administration 585-313-507 Issue 3 April 2000 383

• -n — This option disables prompting from the system whether to wait until

a conflict has been resolved (see the -i option below) or to terminate the

request to attach.

• -i — This option is used to enable secondary command registration. If T1

diagnostics are being run, this option allows the “attaching” of another

card. If -i is used and another maintenance command is being run

(remove, detach, attach, restore, or diagnose), the request to attach is

blocked and a message is printed to the screen. If -i is not used and any

maintenance command is being run, the request to attach is blocked and

a message is printed to the screen.

If the command is permitted to run, it is determined if the command is in

conflict with another command. A command is in conflict if the card or

card associated with the command meets any of the following conditions:

~ T1 card is being diagnosed

~ An interdependency exists with the T1 card being diagnosed (for

example, PRI)

If one of the above conflicts exist and -n is not used, the user is asked

whether to wait until the conflict is resolved or to terminate the request. If

T1 diagnostics are executing online tests and a conflict is detected, the

attach command is blocked. If T1 diagnostics are executing offline tests

and a conflict is detected, the user is asked whether to wait until the

conflict is resolved or to terminate the request to attach.

1 2 ... 417 418 419 420 421 422 423 424 425 426 427 ... 744 745

Comentários a estes Manuais

Sem comentários

HP R4.2 Manual do Utilizador Página 422

Comentários a estes Manuais

Manuais e produtos relacionados com Software HP R4.2