Hp Compaq StorageWorks TL881 DLT Mini-Library Manual do Utilizador descarregar pdf (Página 89)

3-20 Compaq TL881 Minilibrary System Users Guide

SHR-1243

2 x 968312-10

4 x 968313-101

2 x 968319-101 4 x 968320-101

2 x 213164-108 2 x 972629-132

Figure 3-12. Parts List for StorageWorks Metric Rackmounting

Outer slide Front

Intermediate slide Mounting bracket

Inner slide Nut plate;

Lock tab For 1

or 2

modules from top (units 1 and 2)

Rear For 3

or 4

modules from top (units 3 and 4)

NOTE: Brackets for modules 5 and 6 are not shown in Figure 3-12.

WARNING: The cooling fan at the rear of the drive must not be obstructed

when the drive is installed in the rack. It is advisable to allow two inches of

clearance behind the rear panel of the module.

Make certain that when the Module is fully extended that a force of 20% of the

rack weight, but not more than 57 lb. applied in any direction but upwards does

not cause the rack to overbalance.

Metric Conversion Bracket Description and

Identification:

1. Refer to Figure 3-12 to identify and take inventory of the metric

conversion hardware included in your metric rackmount kit.

2. Determine where the module you are installing is going to be located

relative to the top module.

a. If the module you are installing is going to be located on the top of

the stack or the second from the top (unit 1 or 2), the parts which you

will need to install this module are:

2 pieces 968312-101

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 199 200

Sem comentários

Hp Compaq StorageWorks TL881 DLT Mini-Library Manual do Utilizador Página 89