Hp StorageWorks 2.12 Edge Switch Manual do Utilizador descarregar pdf (Página 110)

Configuring the Switch

110 Edge Switch Element Manager User Guide

The Preferred Paths dialog box contains the following columns:

Note: Some columns may only display when the FICON Management Style feature

has been installed.

■ Source Port—Lists the source port of the Preferred Path.

■ Source Addr—(Only displays when using FICON Management Style.) Lists

the source address of the Preferred Path.

■ Exit Port—Lists the exit port of the Preferred Path.

■ Exit Addr—(Only displays when using FICON Management Style.) Lists the

exit address of the Preferred Path.

■ Destination Domain ID—Lists the domain ID of the destination switch. The

range of the destination domain ID number is 1 through 31.

Tip: You may need to configure Preferred Paths on multiple switches or directors to

optimize load balancing for an entire path between devices.

Note: A warning message displays if the switch has not been configured for an

Insistent Domain ID. If this is the case, close the dialog box and click Configure >

Operating Parameters > Switch Parameters. The Configure Switch Parameters dialog

box displays. Click Insistent. Return to the Configure Preferred Paths dialog box and

continue to step 2.

2. Click Add to configure a new Preferred Path. The Add Preferred Path dialog

box displays, as shown in Figure 28.

Figure 28: Add Preferred Path dialog box

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 245 246

Sem comentários

Hp StorageWorks 2.12 Edge Switch Manual do Utilizador Página 110