Hp Tape Library Interface Manager Software Manual do Utilizador Página 117
- Página / 138
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Download Commands 117
Fibre Channel Interface and
Commands
Download Commands
Upgrade Firmware
The upgrade firmware (WRITE_BUFFER)) command is used to transfer
firmware to the Interface Manager over Fibre Channel. Multiple upgrade
firmware commands will be required to accomplish the total transfer. All write
commands except the final write, will have the 3-bit mode field set to 0x06.
The last write command in the sequence will have the mode field bits set to
0x07 to signify the end of transfer. Each WRITE_BUFFER command will return
an FCP response.
Upgrading the firmware is successful when the FCP response returns 0x00
(success). When the transfer process is complete and the firmware image has
been successfully written to FLASH, the Interface Manager will respond to the
last transfer with 0x00, then re-boot with the upgraded firmware. If any errors
occur, the controller will return an FCP_RSP response RC value other than
0x00 and the Interface Manager will abort the upgrade. In this case, the
Interface Manager will not re-boot and the previous version of firmware will
remain intact. The host will issue a WRITE_BUFFER command as described in
Table 4 on page 118.
B
- Part Number: C9578-90000 1
- Edition 1 1
- December 2001 1
- In this manual 2
- Warranty 3
- Reference Standards 4
- Chapter 1 Introduction 11 5
- Chapter 4 SAN Environments 77 8
- Introduction 11
- 12 Introduction Chapter 1 12
- Chapter 1 Introduction 13 13
- Processing SCSI Information 14
- Fibre Channel Features 15
- SCSI Bus Features 15
- Configuration Features 15
- Management Features 16
- Chapter 1 17
- Table 2 Supplied Components 18
- No. Item Qty Description 18
- Specifications 19
- Supported Products 20
- Chapter 1 Introduction 21 21
- Optical Fibre Channel Cables 22
- Interface Manager Overview 23
- Chapter 2 27
- Fibre Channel Port Mode 28
- Hard Addressing 29
- Soft Addressing 29
- Host Device Configuration 30
- SCSI Addressing 30
- Buffered Tape Writes 30
- Address Mapping 31
- Auto-Indexed Mapping 32
- Fixed-Indexed Mapping 32
- Configuration Methods 33
- Web Based Administrator 34
- Management Operations 35
- Management Interfaces 36
- Overview 38
- Accessing Telnet 38
- Chapter 3 41
- Table 7 Time Zones 41
- Using Your Own Settings 44
- Setting Date and Time 56
- Time Shown is NOT Correct 57
- Using DHCP 59
- Administrator 60
- Hard Address Settings 62
- Soft Address Settings 62
- Selecting Your Own Settings 63
- Using the Web Interface 72
- Upgrade Firmware Using FTP 74
- FTP Interface (Single Card) 75
- SAN Environments 77
- Chapter 4 79
- 80 SAN Environments Chapter 4 80
- Omniback Configuration 81
- 82 SAN Environments Chapter 4 82
- Chapter 4 SAN Environments 83 83
- Configuration on page 85 84
- HP-UX Configuration 85
- 86 SAN Environments Chapter 4 86
- Chapter 4 SAN Environments 87 87
- Stopping the dm_stape process 88
- 90 SAN Environments Chapter 4 90
- Chapter 4 SAN Environments 91 91
- file to 91
- Windows Configuration 92
- Solaris Configuration 94
- Switch Configuration 95
- 96 SAN Environments Chapter 4 96
- Troubleshooting 97
- Operation Indicators 99
- 100 Troubleshooting Chapter 5 100
- Chapter 5 Troubleshooting 101 101
- 102 Troubleshooting Chapter 5 102
- Basic Verification 103
- 104 Troubleshooting Chapter 5 104
- NT Control Panel 104
- Chapter 5 105
- 1. Execute an ioscan command 105
- Figure 29.) 105
- Figure 29 ioscan Sample 105
- 106 Troubleshooting Chapter 5 106
- Problem - Solution 107
- 108 Troubleshooting Chapter 5 108
- Chapter 5 Troubleshooting 109 109
- 110 Troubleshooting Chapter 5 110
- Chapter 5 Troubleshooting 111 111
- 112 Troubleshooting Chapter 5 112
- 114 Troubleshooting Chapter 5 114
- DB-9 Serial and RJ-45 115
- Ethernet Pin Assignment 115
- RJ-45 Pin Assignments 116
- Fibre Channel Interface and 117
- Commands 117
- ■ Byte 2 set to 0xFA 118
- Report LUNs Command 119
- PRLI Data 121
- SCSI Interface and Commands 123
- Customer Support 125
- Glossary 127 127
- 128 Glossary 128
- Glossary 129 129
- 130 Glossary 130
- Glossary 131 131
- 132 Glossary 132
- Glossary 133 133
- 134 Glossary 134
- Glossary 135 135
- World Wide Name 136
- Index 137 137
- 138 Index 138
Manuais e produtos relacionados com Armazenamento Hp Tape Library Interface Manager Software
(132 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.039 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais