Hp Tape Library Interface Manager Software Manual do Utilizador descarregar pdf (Página 60)

60 Management Operations Chapter 3

Not Using DHCP

If DHCP is not going to be used:

1. Select [Specify network parameters manually] button.

2. You can now enter the <IP address> desired in the IP address field.

3. In the Subnet Mask field, enter the <Subnet Mask> desired.

4. In the Gateway Address field, enter the <Gateway Address> desired.

5. Select the [Apply] button to load the configuration into the RMC.

Changing the Fibre Channel Address Modes Using the Web

Administrator

Note An administrator’s password is required before any changes can

be submitted.

To change the Fibre Channel address modes using the Web Administrator, do

the following (see Figure 11 on page 61):

1. Access the Web Administrator as described in Making Changes via the

Web Interface on page 56.

2. Select the [Configuration] tab.

3. Select the [Fibre Channel] button.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 137 138

Sem comentários

Hp Tape Library Interface Manager Software Manual do Utilizador Página 60