Hp NonStop G-Series Manual do Utilizador descarregar pdf (Página 46)

The 5157/5157 ACL S-Series Subsystems Installation/Users Guide

Installing and Configuring the 5157 Tape Drive

3-7

Figure 3-6 Rear Panel Components

3.5.2 Connect the SCSI Signal Cable

To connect the SCSI signal cable:

1. Connect one end of the SCSI cable to the rightmost SCSI signal

connector on the 5157 rear panel.

2. Secure the cable with the hand tightening screws.

3. Connect the other end of the SCSI cable to the SCSI connector

on the system, or for daisy-chained configurations, connect the

other end of the SCSI cable to the next SCSI device.

See the system documentation for system SCSI connections.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 180 181

Sem comentários

Hp NonStop G-Series Manual do Utilizador Página 46