Hp ProLiant DL585 G2 Server Manual do Utilizador Página 44
- Página / 104
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Hardware options installation 44
3.
Install the media drive into the server.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
IMPORTANT: By default, the DVD drive is installed in the lower drive bay. To boot from a DVD
or CD-RW drive in the upper drive bay or to boot from a diskette drive in the lower bay,
change the boot device selector switch to FLP BOT ("Boot device selector switch (SW1)" on
page 15).
NOTE: If two DVD or CD-RW drives are installed in the server, the server will first attempt to
boot from the primary drive ("Boot device selector switch (SW1)" on page 15). The boot
device selector switch setting determines which drive is the primary drive.
4. Power up the server (on page 27).
Hot-plug power supplies
The server supports a second hot-plug power supply to provide redundant power to the system in the
event of a failure in the primary power supply. You can install or replace a second hot-plug power supply
without powering down the server.
WARNING: To reduce the risk of electric shock or damage to the equipment:
• Do not disable the power cord grounding plug. The grounding plug is an important safety
feature.
• Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all
times.
• Unplug the power cord from the power supply to disconnect power to the equipment.
• Do not route the power cord where it can be walked on or pinched by items placed against
it. Pay particular attention to the plug, electrical outlet, and the point where the cord
extends from the server.
- User Guide 1
- Audience assumptions 2
- Contents 3
- Contents 4 4
- Contents 5 5
- Component identification 6
- Front panel LEDs and buttons 7
- DIMM slot identification 9
- SAS and SATA hard drive LEDs 9
- Rear panel components 11
- Rear panel LEDs and buttons 12
- Internal components 12
- Item Description 13
- Media board components 14
- Systems Insight Display LEDs 16
- Battery pack LEDs 17
- Fan locations 18
- Hot-plug power supply LEDs 19
- Rack planning resources 21
- Optimum environment 22
- Rack warnings and cautions 23
- Setup 24 24
- Installing hardware options 25
- Registering the server 26
- Operations 27
- Removing the access panel 28
- Hot-plug fans 30
- Removing the system battery 31
- Introduction 32
- Processor options 32
- Installing a processor 34
- 12. Install the heatsink 38
- 14. Install the PPM 39
- Memory options 40
- Hard drive guidelines 41
- 1. Prepare the hard drive 42
- Hot-plug power supplies 44
- Expansion boards 46
- Battery-backed write cache 48
- Remove the controller 49
- Cabling 52
- Front panel cable components 53
- Configuration tools 54
- HP ROM-Based Setup Utility 55
- Boot options 56
- BIOS Serial Console 56
- Array Configuration Utility 57
- Management tools 58
- Management Agents 59
- HP Systems Insight Manager 59
- Redundant ROM support 59
- ROMPaq utility 60
- USB support 60
- Diagnostic tools 61
- Keeping the system current 62
- Care Pack 63
- Troubleshooting 64
- Symbols on equipment 65
- Warnings and cautions 65
- Symptom information 66
- Loose connections 67
- Service notifications 68
- Troubleshooting flowcharts 68
- General diagnosis flowchart 69
- Symptoms: 71
- Troubleshooting 73 73
- POST problems flowchart 74
- OS boot problems flowchart 75
- • Redundancy failure 78
- Troubleshooting 79 79
- FCC rating label 80
- Class A equipment 80
- Class B equipment 80
- Modifications 81
- • EMC Directive 2004/108/EC 82
- Japanese notice 83
- BSMI notice 83
- Korean notice 84
- Laser compliance 84
- Battery replacement notice 84
- Electrostatic discharge 86
- Specifications 87
- Specification Value 88
- Technical support 89
- Technical support 90 90
- Customer Self Repair 91
- Technical support 92 92
- Reparo feito pelo cliente 93
- Technical support 94 94
- Technical support 95 95
- Technical support 96 96
- Acronyms and abbreviations 97
- Version Control Agent 100
- Index 101 101
- Index 102 102
- Index 103 103
- Index 104 104
Manuais e produtos relacionados com Hardware de computador Hp ProLiant DL585 G2 Server
(117 páginas)DeVilbiss COMPACT P2-11 manuály
Uživatelské manuály a uživatelské příručky pro Stříkací barva DeVilbiss COMPACT P2-11.
Poskytujeme 2 manuály pdf DeVilbiss COMPACT P2-11 ke stažení zdarma podle typů dokumentů: Uživatelský manuál, Specifikace
Comentários a estes Manuais