HP DV3 Informações Técnicas descarregar pdf (Página 54)

2. Remove the two Phillips PM2.0×4.0 screws that secure the WLAN module to the system board.

(The WLAN module tilts up.)

3. Remove the WLAN module by pulling the module away from the slot at an angle.

NOTE: WLAN modules are designed with a notch (4) to prevent incorrect insertion of the

WLAN module into the WLAN module slot.

NOTE: If the WLAN antennas are not connected to the terminals on the WLAN module, the

protective sleeves must be installed on the antenna connectors, as shown in the following illustration.

Reverse this procedure to install the WLAN module.

44 Chapter 4 Removal and replacement procedures

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 115 116

Sem comentários

HP DV3 Informações Técnicas Página 54