HP Pavilion DV6000t Informações Técnicas descarregar pdf (Página 83)

Top cover (see

Top cover on page 66)

Audio board (see

Audio board on page 77)

USB/power connector board (see

USB/power connector board on page 73)

When replacing the system board, be sure that the following components are removed from the defective

system board and installed on the replacement system board:

●

Memory modules (see

Memory module on page 47)

●

RTC battery (see

RTC battery on page 49)

●

WLAN module (see

WLAN module on page 50)

●

Bluetooth module (see

Bluetooth module on page 70)

●

ExpressCard assembly (see

ExpressCard assembly on page 71)

●

Fan/heat sink assembly (see

Fan/heat sink assembly on page 78)

●

Processor (see

Processor on page 80)

Remove the system board:

1. Remove the USB/power connector board cable (1) from the clips built into in the base enclosure.

2. Remove the two Phillips PM2.5×4.0 screws (2) that secure the system board to the base enclosure.

3. Use the optical drive connector (1) to lift the right side of the system board (2) until it rests at an

angle.

4. Disconnect the audio board cable (3) from the system board.

ENWW Component replacement procedures 75

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 147 148

Sem comentários

HP Pavilion DV6000t Informações Técnicas Página 83