
4 Finish setting up the HP All-in-
One
After you have completed the steps in your Start Here guide, refer to this section to help
you finish setting up the HP All-in-One. This section contains important setup-related
information for your product.
This section contains the following topics:
•
Set your preferences
•
Connect to a computer
•
Connect to a Bluetooth® device
Set your preferences
Before you begin using your product, you should review and, if necessary, adjust the
general settings described in this section.
This section contains the following topics:
•
Set your language and country/region
•
Set the default paper tray for PictBridge/DPOF/UPnP printing
•
Enable faster browsing of photos
•
Set the energy save mode
•
Set the paper tray for printing from a Bluetooth device
•
Restore the factory defaults
•
Play a slideshow on the display
Set your language and country/region
The language setting determines which language the HP All-in-One uses to show
messages on the display. The country/region setting determines the default paper sizes
and layouts for printing. You can change these settings at any time by using the following
procedure.
To set your language and country/region
1. Press Setup.
2. Press the down arrow button to highlight Preferences, and then press OK.
3. Press the down arrow button to highlight Set Language, and then press OK.
4. Press the down arrow button to scroll through the languages. When the language you
want to use is highlighted, press OK.
Set your preferences 19
Finish setup
Comentários a estes Manuais