HP 620n Guia do Utilizador descarregar pdf (Página 34)

ENWW 34

TCP/IP Configuration

Introduction

To operate properly on a TCP/IP network, the HP Jetdirect print

server must be configured with valid TCP/IP network configuration

parameters, such as an IP address that is valid for your network.

For general information on TCP/IP networks, see Appendix A

Server-Based and Manual TCP/IP Configuration

When in a factory-default state and powered on, the HP Jetdirect

print server will try to obtain its TCP/IP configuration using a

server-based method, such as BOOTP/TFTP, DHCP/TFTP, or

RARP. These server-based methods are described later in this

chapter. Depending on the print server model, up to two minutes

may be used for these methods. If configuration is not successful, a

default IP address will be assigned.

The print server may also be configured manually. Manual-based

tools include Telnet, a Web browser, the printer control panel, arp

and ping commands (when the default IP address is 192.0.0.192),

or SNMP-based management software. TCP/IP configuration

values assigned manually will be retained when powered off/on.

The print server can be reconfigured to use either server-based or

manual configuration of TCP/IP settings at any time.

To identify the IP address that is configured on the print server at

any time, see the HP Jetdirect configuration page.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 263 264

Sem comentários

HP 620n Guia do Utilizador Página 34