HP C200 Manual do Utilizador descarregar pdf (Página 6)

Capstone Turbine Corporation  21211 Nordhoff Street  Chatsworth  CA 91311  USA

Product Specification: Model C200 - Capstone MicroTurbine

460045 Rev C (November 2008) Page 6 of 16

Capstone reserves the right to change or modify, without notice, the design, specifications, and/or contents of this document

without incurring any obligation either with respect to equipment previously sold or in the process of construction.

Table 4 presents the electrical performance ratings for C200 MicroTurbines operating in the

Stand Alone mode at ISO conditions.

Table 4. Electrical Performance Ratings in Stand Alone Mode

Parameter C200 Low Pressure NG All Other C200

Net Power Output

190 (+0/- 4) kW 200 (+0/- 4) kW

Max Apparent Power Output

(1)

258 kVA at 480 VAC 258 kVA at 480 VAC

Nominal Voltage Operating Range

400 to 480 VAC 400 to 480 VAC

Frequency Operating Range

10 to 60 Hz 10 to 60 Hz

Output Voltage Connection

(2)

3-phase, 4 wire wye 3-phase, 4 wire wye

Max Output Current

(3)

310 Amps RMS

steady state

310 Amps RMS

steady state

Voltage THD

IEEE 519 Compliant, 5% IEEE 519 Compliant, 5%

Notes:

(1) System power factor is limited by maximum current in Stand Alone mode

(2) Neutral must be solidly grounded

(3) Values assume linear load

Performance Derating

Performance is affected by ambient temperature and elevation. The performance ratings

listed above are at full load power at ISO conditions. Performance derating occurs at ambient

temperatures and elevations above ISO conditions and is also affected by air inlet pressure,

back pressure, and system parasitic loads (e.g. fuel gas compressor, battery charging).

Typical derating curves for power output and efficiency based on ambient temperature are

shown in the curves on the following pages. These curves assume no external parasitic loads

no inlet air restrictions, and no exhaust back pressure.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Sem comentários

HP C200 Manual do Utilizador Página 6