HP rp2450 Manual descarregar pdf (Página 163)

Chapter

Server Cover Replacement

235

Server Cover Replacement

The cover that protects rp24xx server components must be raised in front and positioned on top of the side

chassis panels then lowered and slid into the back chassis panel. The cover is secured by two thumbscrews

attached to the front chassis panel.

To replace the cover, perform the following procedures:

Step 1. Tilt the cover front up slightly and position it on top of the chassis side panels approximately 2.5

MM (1 in.) from the rear of the server chassis.

Step 2. Lower and slide the cover back over the notches on each side of the front of the server and seat it

against the rear chassis panel.

Step 3. Fasten the two captive knurled thumbscrews located near the bottom edge of the front of the server

cover.

CAUTION The server weighs approximately 23 kg (50 lbs). Take necessary precautions to prevent muscle

strain when lifting and carrying the server.

The following graphic shows the server cover suspended over the server.

1 2 ... 158 159 160 161 162 163 164 165 166 167 168 ... 201 202

Sem comentários

HP rp2450 Manual Página 163