HP rp2450 Manual descarregar pdf (Página 199)

Chapter

Extend a Server From the Rack

295

Extend a Server From the Rack

rp24xx servers are available in three configurations: rack-mounted, stacked, or stand-alone. Access to servers

mounted in an HP-supported rack is covered in this section.

NOTE Ensure that there is enough area (Approximately 82 centimeters (32 in.) to fully extend the

server out the front and work on it.

WARNING Ensure that all anti-tip features (front anti-tip feet installed; adequate ballast

properly placed, etc.) are employed prior to extending the server.

To extend the server, perform the following steps:

Step 1. Remove the front Bezel.

Step 2. Remove the four T-25 screws that fasten each side of the server to the rack.

WARNING DO NOT press the rail clips after they reach the stops. Defeating this safety

feature when the server is fully extended will cause it to be pulled

completely off the rails. Servers weigh approximately 50 lbs each and

failure to observe this precaution can cause serious injury and/or

equipment damage.

Step 3. Grasp the server chassis and slowly pull forward. The server is fully extended when the rail clips

are locked in place.

The following graphic shows the server extended and indicates the rail clip location.

ccrr014

1 2 ... 194 195 196 197 198 199 200 201 202

Sem comentários

HP rp2450 Manual Página 199