HP Workstation x4000 Especificações descarregar pdf (Página 179)

Installing or Replacing Parts and Accessories

Processor

Chapter 10 177

Installing a Processor

To install a processor:

1. Turn off the display and shut down the Workstation. Disconnect all

power cables and any LAN or telecommunications cables.

2. Remove the Workstation’s cover (see page 145).

3. Place the Workstation on its side for better access.

4. Open the hard disk drive cage (see page 149).

5. Remove the Chassis Beam Assembly (see page 152).

6. Remove the MEC card (see page 162).

7. Ensure the processor is correctly oriented by matching the notches on

the processor to the notches on the ZIF socket. Then carefully lower

the new processor into place. When the processor is fully inserted,

close the ZIF lever.

CAUTION Be extremely careful when you insert the processor. If you bend one of

the pins, it will not go into the socket.

Figure 10-22 Inserting a Processor

8. Afﬁx the new thermal interface material, provided with the new

processor, to the top of the processor.

9. Attach the heatsink to the processor. Use the retaining clips to attach

the heatsink. For easier installation, partially attach both clips by

hooking one end of the side slot in each clip. Press down on the

remaining ends of both clips until they click into place.

Step 7

Step 9

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 237 238

Sem comentários

HP Workstation x4000 Especificações Página 179