HP Workstation x4000 Especificações descarregar pdf (Página 52)

System BIOS and Resources

HP Setup Program

Chapter 452

Advanced Menu

Table 4-2 describes the submenus available in the Setup program

Advanced menu.

Table 4-2 Advanced Menu

Field Description

Processors Displays the type and the speed of the processor(s)

you have in your Workstation. You can change your

processor speed in the Processor Speed ﬁeld by

selecting a value from the drop down menu. Your

processor cannot run any faster than what is

displayed in the Current Type ﬁeld. If you leave

Processor Speed set to the default of Auto, the

processor speed is automatically detected. Use a

ﬁxed frequency for troubleshooting only.

Chipset Memory Error Checking: You can choose between

ECC and Disabled. ECC scrubbing checks for and

corrects errors at the source to prevent them from

reoccurring. Change this ﬁeld to Disabled if you want

to ﬁnd errors, but don’t want them corrected.

ECC Error Type: When an ECC error occurs, it

generates an interrupt. In this ﬁeld, you can select

the type of interrupt you want reported: NMI

(Non-Maskable), SMI (System Management), SCI,

(System Control), or None.

SERR signal condition: In this ﬁeld, you can select

the type of ECC error condition that triggers a

critical system error (SERR#). Normally, only Multiple

bit

(unrecoverable) errors should be able to trigger

SERR#. But you can also choose Single bit, None, or

Both.

Floppy Disk

Drive

Contains the ﬂoppy disk drive type and controller

ﬁelds. If you choose to disable your ﬂoppy disk drive,

you must also disable your ﬂoppy disk controller.

IDE Devices Lets you conﬁgure the settings for the IDE controller

and any attached IDE devices.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 237 238

Sem comentários

HP Workstation x4000 Especificações Página 52